Gas cylinder wood burner

[Dorset Lad]

I've just cut out the door and next job is welding on hinges and a latch to keep the cut out bit back where it came from.
The thing I'm now starting to wonder is, do I need to cut any holes below the grate to allow enough air in when the door is shut or will it burn well enough without? I'm just looking for warmth, not an infurno!
Has anyone else made one or have any experience of one?

[Barneyboy]

I've just cut out the door and next job is welding on hinges and a latch to keep the cut out bit back where it came from.
The thing I'm now starting to wonder is, do I need to cut any holes below the grate to allow enough air in when the door is shut or will it burn well enough without? I'm just looking for warmth, not an infurno!
Has anyone else made one or have any experience of one?

can we have some pics pal

[uks]

Cant you find a small engineering company or a local garage to do the cutting and welding?

[Hrusai]

[Dorset Lad]

The welding and cutting is no problem, I restore classic cars as a hobby.
The bit I'm not sure about is how much air is needed under the grate.
I'll take some pics next time I'm working on it.

---

Thanks for the link Hrusai, It has given me some ideas for an air regulator.

PS If you think Dorchester and Yeovil are s**t holes, you should try Weymouth! Especially now half of it is closed for the olympics.

[Hrusai]

[Skvez]

The bit I'm not sure about is how much air is needed under the grate.

Most fires have some form of (dedicated) air intake and some means to adjust how much air gets through it.
It's common to open up the air intake to get the fire burning and then close it down to slow the fire down to make the fuel last longer.

[BDG]

Here is one I made earlier in the year. Two bottles, top of one chopped off, bottom of other chopped off, welded together for the hight, door cut and hole for chimney. Welded a baffle in the top so exhaust gases are driven towards the front then have to go to the back to go up the chimney. There is a scaffold bar I cut and welded into a kind of Z shape, but with the middle bit vertical - goes out of the back of the stove.

On lighting, I keep the door open, once it gets hot, close the door and the heat inside pulls in air through the scaffold for a re-burn just below the baffle. Door leaks enough for primary burn, was going to make it seal with fire rope and make an air inlet on the front but then thought 'Why, it works and as it is not coming in the house not going to worry about CO leakage'.

Depending on what is going on in the greenhouse in winter and spring, that is when it will be getting used. Would have made an open vented boiler too but do not have the time or the need to warrant using the time.

All of the paint is burnt off now, I may clean it up and put some stove paint on. I may not.