Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
dont be put off...
9 December 2011, 17:41,
#6
RE: dont be put off...
(9 December 2011, 13:40)mikebratcher69 Wrote: I doubt it, It's a good site best one I've been on so far, relevent, and not o.t.t. "keep it simples" as the meerkat says...


Simple works.

As for costs, it is up and down we should not buy to cheap and have something that is going to break on us after X amount of use, I tend to target military surplus to meet my target range of supplies and not break the bank.

Plus ex-army gear/kit is built to last in most cases, for example say average prepper has 500/1000 cans of food, you’re going to need something that is proven and heavy duty post shtf to open the tins, I mean in most cases we won’t be able to go buy a new can opener when our cheap one breaks right?,

so look at this Bonzer Professional Tin opener 15 pound from military mart, I bought two one for use now and one in with my prep stores, even if I bought another equal 3 I still would be saving on the price of the cheapest one online which I think is around £55.

Link for interest:

http://www.militarymart.co.uk//Bonzer-Pr...d_670.html

I built up a solar build and tried to make it as cheap as I could but it still was quite a few pounds but worth that investment, again your wording "simple" works in this case as in I priced it and made it to meet my needs post shtf.

Good Post Mike.
Reply


Messages In This Thread
dont be put off... - by mikebratcher69 - 9 December 2011, 11:16
RE: dont be put off... - by NorthernRaider - 9 December 2011, 11:28
RE: dont be put off... - by bigpaul - 9 December 2011, 11:37
RE: dont be put off... - by Skean Dhude - 9 December 2011, 12:36
RE: dont be put off... - by mikebratcher69 - 9 December 2011, 13:40
RE: dont be put off... - by Nemesis - 9 December 2011, 17:41
RE: dont be put off... - by bigpaul - 9 December 2011, 17:48
RE: dont be put off... - by Nemesis - 9 December 2011, 18:01
RE: dont be put off... - by bigpaul - 9 December 2011, 18:07
RE: dont be put off... - by Nemesis - 9 December 2011, 18:43
RE: dont be put off... - by bigpaul - 10 December 2011, 11:08
RE: dont be put off... - by Skean Dhude - 9 December 2011, 22:42
RE: dont be put off... - by mikebratcher69 - 10 December 2011, 18:52
RE: dont be put off... - by bigpaul - 11 December 2011, 11:27

Forum Jump:


Users browsing this thread: 1 Guest(s)