Fuel from waste plastics

[BFG Central]

Best is the chinese company that makes the machine.

Yes fairly high temperatures are needed but there is very low pressure involved.
You could build something with an old gas cylinder as the heating chamber.
On a small scale you would want an automatic feed that is air tight.
This cylinder is put inside an insulated burn chamber to make it efficient.
But you could make single loads if it was just for yourself and then wait for it to cool down and then do another batch.
When they do this with car tyres they do it in one large load which is manually loaded and then heated.

There is so much of this going on around the world.
But in the UK it seems there is very little development.
There was a welsh company developing this system a while back but iv not heard anything about them for a while??

So much of our plastic waste is being bailed up and shipped abroad for them to recycle and we pay to get rid of the stuff.