Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Jug Choking
1 August 2014, 22:10,
#16
RE: Jug Choking
Very disappointing results Mort.I have a 24 1/2 "" cylinder bore as my primary tool.As of yet I haven't taken it to the pattern plate with a .690 ball.Your results don't give me much hope that I did the right thing cutting off the choke.
All of the research I've done indicates a cylinder bore is best for slugs /ball(Legally I can't pattern a slug and I wouldn't want to risk being banned from my primary clay ground for testing,not to mention any legal infractions ).
very disappointing results,and another indicator that I shouldn't rely on internet data,though trying to stay legal means that it's still my primary resource.
I have shot it with 7.5 shot with good results at sporting clays though, so hunting small game is still perfectly viable.Still your results give me some concern.
Reply


Messages In This Thread
Jug Choking - by Mortblanc - 18 July 2014, 20:40
RE: Jug Choking - by CharlesHarris - 18 July 2014, 21:16
RE: Jug Choking - by Mortblanc - 18 July 2014, 22:09
RE: Jug Choking - by Steve - 18 July 2014, 22:38
RE: Jug Choking - by Mortblanc - 18 July 2014, 23:24
RE: Jug Choking - by Mortblanc - 24 July 2014, 02:27
RE: Jug Choking - by Skean Dhude - 24 July 2014, 10:32
RE: Jug Choking - by CharlesHarris - 24 July 2014, 18:27
RE: Jug Choking - by Mortblanc - 24 July 2014, 23:14
RE: Jug Choking - by CharlesHarris - 25 July 2014, 00:33
RE: Jug Choking - by Mortblanc - 25 July 2014, 08:14
RE: Jug Choking - by CharlesHarris - 25 July 2014, 17:16
RE: Jug Choking - by Mortblanc - 25 July 2014, 17:57
RE: Jug Choking - by Lightspeed - 31 July 2014, 20:09
RE: Jug Choking - by Mortblanc - 31 July 2014, 23:14
RE: Jug Choking - by Talon - 1 August 2014, 22:10
RE: Jug Choking - by Midnitemo - 2 August 2014, 10:11
RE: Jug Choking - by Mortblanc - 2 August 2014, 12:38
RE: Jug Choking - by Midnitemo - 2 August 2014, 16:01
RE: Jug Choking - by Mortblanc - 2 August 2014, 21:46

Forum Jump:


Users browsing this thread: 3 Guest(s)