Survival UK Forums › Discussion Area › Hunting › Guns v
Cutting Shotgun Barrels

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Cutting Shotgun Barrels
20 March 2015, 20:29,
#14
Talon Offline
Member
 		Posts: 230
Threads: 4
Joined: Feb 2013
Reputation: 2
RE: Cutting Shotgun Barrels
Some very good information Mort.Funnily enough I do have an A5 with a full choke and never thought it would be safe to (theoretically) fire slugs through it,i take it a .690 ball would be just as safe as a slug?.
I'm glad after reading this thread that the only cylinder bore gun I have is a cheap Cooey, though I have been dabbling with the idea of soldering a Polychoke on to it to make it more versatile.
I was also considering doing it to my A5 but I would hate to ruin the lines of it,though it would greatly increase it's versatilityConfused.
Find
Reply


Messages In This Thread
Cutting Shotgun Barrels - by Mortblanc - 19 March 2015, 01:40
RE: Cutting Shotgun Barrels - by CharlesHarris - 19 March 2015, 03:04
RE: Cutting Shotgun Barrels - by Midnitemo - 19 March 2015, 03:48
RE: Cutting Shotgun Barrels - by Mortblanc - 19 March 2015, 04:50
RE: Cutting Shotgun Barrels - by Midnitemo - 19 March 2015, 15:55
RE: Cutting Shotgun Barrels - by Mortblanc - 19 March 2015, 17:11
RE: Cutting Shotgun Barrels - by Midnitemo - 19 March 2015, 17:32
RE: Cutting Shotgun Barrels - by Mortblanc - 19 March 2015, 17:40
RE: Cutting Shotgun Barrels - by Steve - 19 March 2015, 20:05
RE: Cutting Shotgun Barrels - by CharlesHarris - 19 March 2015, 21:33
RE: Cutting Shotgun Barrels - by Steve - 19 March 2015, 22:17
RE: Cutting Shotgun Barrels - by CharlesHarris - 20 March 2015, 01:00
RE: Cutting Shotgun Barrels - by Mortblanc - 20 March 2015, 16:49
RE: Cutting Shotgun Barrels - by Talon - 20 March 2015, 20:29
RE: Cutting Shotgun Barrels - by Steve - 20 March 2015, 21:42
RE: Cutting Shotgun Barrels - by Mortblanc - 22 March 2015, 19:41
RE: Cutting Shotgun Barrels - by Steve - 22 March 2015, 20:14
RE: Cutting Shotgun Barrels - by CharlesHarris - 23 March 2015, 02:38

Forum Jump:


Users browsing this thread: 1 Guest(s)