Search
Calendar
Help
3 February 2017, 20:06
Looking at the suggested load data for both cartridges, and looking at the firearm designs available for the 38S&W/380 I would have to place design restrictions on the use of "overloaded" .38 S&W rounds.
An "overload", meaning a .38 S&W round loaded to .38 spl standards, might be tolerable in a S&W model 10, or a Colt New Police revolver made during or after WW2. Both of those designs were manufactured to the same strength in both rounds as a matter of normal production. Both of those designs were routinely rechambered for .38spl by surplus dealers by the simple act of running a reamer into the cylinder. They continued to function flawlessly right up til today with the only normal complaint being that they swell the cases a bit on firing.
It would be different for the many Webley, Enfield, S&W top break, Iver Johnson and H&R revolvers. None of them are made to the same strength levels as the solid frame, side swing cylinder, Colt and S&W designs.
It is the weak hinge at the front and the potential for excess wear on the top latch that would concern me. I have seen many of the old top break revolvers that were worn to uselessness using standard loads, so an overload would be unacceptable in those designs.
An "overload", meaning a .38 S&W round loaded to .38 spl standards, might be tolerable in a S&W model 10, or a Colt New Police revolver made during or after WW2. Both of those designs were manufactured to the same strength in both rounds as a matter of normal production. Both of those designs were routinely rechambered for .38spl by surplus dealers by the simple act of running a reamer into the cylinder. They continued to function flawlessly right up til today with the only normal complaint being that they swell the cases a bit on firing.
It would be different for the many Webley, Enfield, S&W top break, Iver Johnson and H&R revolvers. None of them are made to the same strength levels as the solid frame, side swing cylinder, Colt and S&W designs.
It is the weak hinge at the front and the potential for excess wear on the top latch that would concern me. I have seen many of the old top break revolvers that were worn to uselessness using standard loads, so an overload would be unacceptable in those designs.
__________
Every person should view freedom of speech as an essential right.
Without it you can not tell who the idiots are.
Every person should view freedom of speech as an essential right.
Without it you can not tell who the idiots are.