Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Quick help please check my maths
7 September 2012, 15:14,
#4
RE: Quick help please check my maths
I'd go for the tight fit even if it meant the heads may need to be forced in place as when they will have less flex. If they become damaged and have to be removed you have may damage the shaft but then you can have a loose fit.

HOWEVER : That is my viewpoint as an engineer. Maybe the heads need replacing frequently and glue is easier to remove than a tight and glue fitting. If someone has a better opinion then I'd go with that.
Skean Dhude
-------------------------------
It is not the strongest of the species that survives, nor the most intelligent that survives. It is the one that is the most adaptable to change. - Charles Darwin
Reply


Messages In This Thread
Quick help please check my maths - by NorthernRaider - 7 September 2012, 11:56
RE: Quick help please check my maths - by Skean Dhude - 7 September 2012, 11:59
RE: Quick help please check my maths - by Skean Dhude - 7 September 2012, 15:14
RE: Quick help please check my maths - by Skean Dhude - 7 September 2012, 16:18
RE: Quick help please check my maths - by bigpaul - 11 September 2012, 14:03
RE: Quick help please check my maths - by John - 12 September 2012, 07:42
RE: Quick help please check my maths - by John - 12 September 2012, 15:18
RE: Quick help please check my maths - by Metroyeti - 12 September 2012, 08:53
RE: Quick help please check my maths - by bigpaul - 12 September 2012, 08:57
RE: Quick help please check my maths - by Skvez - 12 September 2012, 10:26
RE: Quick help please check my maths - by Metroyeti - 12 September 2012, 18:23

Forum Jump:


Users browsing this thread: 2 Guest(s)