SUK HT PROGRAMMING PROTOCOL (proposal)

[The Local Ned]

ATTENTION.

From CHIRPS UV-5R page :

"IMPORTANT NOTE:
Although CHIRP image files are interchangeable between radios with Firmware BFB290 and prior, this is NOT true with newer releases BFB291 and newer.

If you have a radio with Firmware BFB291 and one with BFB293, you MUST have a separate image file for each."

Our channel image files were done with the supplied VIP software, which WERE compatible , just make sure if/when you swap setup files - they are done by VIP and not CHIRP.

---

(17 November 2012, 15:21)Paul Wrote: Now if you haven't thought about it yet, lets set up your local HF coverage i.e. the humble CB set.
No programming needed, easy peasy.

Two channels 9 and 19.
09 (27.68125 MHz, UK, NFM) For dedicated Emergency traffic
19 (27.78125 MHz, UK, NFM) For general contacts and for initial emergency contact.

For interest, The European Frequencies
09 (27.06500 Mhz, CEPT, EU, US, AM) For dedicated Emergency traffic
19 (27.20500 MHz, CEPT, EU, US, AM) For general contacts and for initial emergency contact.

Nearing the final choice on a new CB mate , probably will be only low and mids though , no hi