UV5r Initial configuration & On the fly programming.

[Steve]

(23 September 2013, 21:15)River Song Wrote: OK - so using the cable rather than hand programming what do I do?

The hand programming looks fine until step 8 is complete and then it appears lots
of steps rolled into just a few i.e. Rinse and Repeat

Is it easier to use a program ??

I did mine via the keypad, don't have the cable or software.

It was trial and error really, the manual makes little sense. Remember that when you save a channel to a memory location the first time it saves the TX frequency, the second time it saves the RX frequency. At least that's what mine do.

I can't remember every step off the top of my head, but can make a guide tomorrow evening.