Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Introducing: THE BEAST!
1 May 2014, 23:58,
#17
RE: Introducing: THE BEAST!
Its just a fiscal balancing act.....getting the job done for a reasonable amount of money , all nice knives but I reckon I could get the job done cheaper (i like Boker and there a bit cheaper like for like,not much though Big Grin) but it's about you're personal requirements and standards+ there's nothing wrong with a bit of kit lust if you have the funds to do it....bit of pride in a nice blade....I get it!
Nothing is fool proof for a sufficiently talented fool!!!!
Reply


Messages In This Thread
Introducing: THE BEAST! - by Ian Haines - 1 May 2014, 06:41
RE: Introducing: THE BEAST! - by Sunna - 1 May 2014, 11:15
RE: Introducing: THE BEAST! - by BeardyMan - 1 May 2014, 14:18
RE: Introducing: THE BEAST! - by Barneyboy - 1 May 2014, 17:19
RE: Introducing: THE BEAST! - by BeardyMan - 1 May 2014, 17:42
RE: Introducing: THE BEAST! - by bigpaul - 1 May 2014, 17:45
RE: Introducing: THE BEAST! - by BeardyMan - 1 May 2014, 17:51
RE: Introducing: THE BEAST! - by bigpaul - 1 May 2014, 17:57
RE: Introducing: THE BEAST! - by BeardyMan - 1 May 2014, 18:03
RE: Introducing: THE BEAST! - by bigpaul - 1 May 2014, 18:06
RE: Introducing: THE BEAST! - by Scythe13 - 1 May 2014, 19:05
RE: Introducing: THE BEAST! - by BeardyMan - 1 May 2014, 19:53
RE: Introducing: THE BEAST! - by Scythe13 - 1 May 2014, 20:07
RE: Introducing: THE BEAST! - by Barneyboy - 1 May 2014, 20:17
RE: Introducing: THE BEAST! - by BeardyMan - 1 May 2014, 20:52
RE: Introducing: THE BEAST! - by Barneyboy - 1 May 2014, 21:06
RE: Introducing: THE BEAST! - by Midnitemo - 1 May 2014, 23:58
RE: Introducing: THE BEAST! - by Ian Haines - 2 May 2014, 00:46
RE: Introducing: THE BEAST! - by BeardyMan - 2 May 2014, 08:07
RE: Introducing: THE BEAST! - by BeardyMan - 2 May 2014, 11:14
RE: Introducing: THE BEAST! - by Sunna - 2 May 2014, 14:12
RE: Introducing: THE BEAST! - by Tartar Horde - 3 May 2014, 10:57

Forum Jump:


Users browsing this thread: 3 Guest(s)